IO391: FPGA I/O module with 26 digital I/O lines for Simulink

IO391

Configurable I/O module

The IO391 I/O module is a mini-PCIe-compatible, configurable I/O module with 50k logic cells, 26 ESD-protected TTL I/O lines and a AMD^® Artix^®-7 chip.

All the I/O lines are individually programmable as input or output and can be set to high, low or tristate.

Each TTL I/O line also has a pull resistor to a common programmable pull voltage that can be set to +3.3 V, +5 V and GND.

The IO391 I/O module also has a basic heatsink to facilitate thermal management. The heatsink can be used to install additional cooling solutions like passive or active heatsinks or to provide a thermal connection to an enclosure.

Key Features

26x ESD-protected TTL I/O lines with pull resistors
Voltage levels of 3.3 V, 5 V, or ground, and input/output directions that are software configurable by I/O line
Configuration of the I/O module using Simulink blocks from the Speedgoat I/O Blockset library as part of the Simulink^® Real-Time™ workflow

Physical
Form factor	mPCIe
Power requirements	+3.3 Vaux: 650 mA typical
Bus	PCIe
Connectors	Digital 1: 17-pin M12 male Cable connector: Phoenix Contact M12 17-pos female connector Board connector: Phoenix Contact part no. 1442078 Digital 2: 17-pin M12 female Cable connector: Phoenix Contact M12 17-pos male connector Board connector: Phoenix Contact part no. 1442081
Environmental
Operating temperature	-40°C to +85°C
Relative humidity	5 to 95%, non-condensing
FPGA
FPGA chip	AMD^® Artix-7 XC7A50T
No. of logic cells available	52160
Block RAM (Kb)	2700
DSP slices	120
I/O
Digital	26 x ESD-protected TTL I/O lines with pull-resistors. Voltage levels of 3.3V, 5V, or ground, and input/output directions are software configurable by I/O line
Inter-module communication	8 MGT on XMC P16 Connector
Reliability
Mean time between failures (MTBF)^*	987,000 hours

MTBF (Mean Time Between Failure) - MTBF values shown are based on calculation according to MIL-HDBK-217F and MIL-HDBK-217F Notice 2; Environment: GB 20°C. The MTBF calculation is based on component FIT rates provided by the component suppliers. If FIT rates are not available, MIL-HDBK-217F and MIL-HDBK-217F Notice 2 formulas are used for the FIT rate calculation.

Item ID	Product Name	Components
2A391X	IO391	1 x IO391 I/O module 2x 17-Pin Male M12 to 17-Pin Female M12 Cable (3 ft/0.91 m) 1x 2-way 17-Pin M12 Terminal Board Driver block library for Simulink^® Real-Time™ Simulink^® test models Comprehensive documentation and Simulink^® example models Installation into the real-time target machine

Key to X in Item ID
Please replace the X with the code number of the specific target machine into which this I/O module shall be installed:

7 = Unit real-time target machine
8 = Baseline real-time target machine

Pricing information
We do not publish pricing information on our website. Upon request by e-mail or phone,we can provide a complete price list covering our entire product portfolio in various currencies. We recommend that you contact us to discuss your specific needs. We can then quickly provide you with a tailored quotation including technical and pricing information.